Release Film for Anycubic Photon Mono M7 Max (390 × 263 mm) – FEP, PFA

Release Film for Anycubic Photon Mono M7 Max (390 × 263 mm) – FEP, PFA (nFEP) or ACF

$88.00

1 left

Pickup available at Gold Coast, Queensland. (Check Pickup Hours)

Usually ready in 2 hours

Order before 3pm for same-day dispatch via Australia Post. 2-5 business days to most of Australia. Shipping rates and policy

Free shipping on orders over $120 (excluding 3D printers)

Flexible returns

Pre-cut release film for the Anycubic Photon Mono M7 Max, cut to 390 × 263 mm so it drops straight into the vat frame with no measuring, no cutting and no wasted roll. Sheets are cut from fresh factory rolls, packed flat with protective liners, and shipped from our Gold Coast store.

Choose your film type from the Film type option above — FEP, PFA (nFEP) or ACF. Not sure which to pick? See the comparison below and in the product images.

Changing your film is a ten-minute job — follow our Installation Guide.

Which film should I choose?

FEP (5 pack) — the proven everyday film. Standard fluoropolymer release film. Clear, affordable and forgiving. Five sheets per pack so you always have spares on the shelf.
PFA nFEP (2 pack) — lower peel force, longer life. nFEP is a PFA-based film with a lower surface tension than FEP, so models release with less peel force. Gentler on fine supports, quieter, and it lasts noticeably longer between changes. Two sheets per pack.
ACF (2 pack) — the fast-print film. ACF is the frosted, textured release film that ships on many current printers such as the Saturn 4 Ultra and Photon Mono M7 series. Its micro-texture breaks the vacuum between the model and the film, allowing much faster lift speeds and a low peel force on large flat layers. Two sheets per pack.

	FEP	PFA (nFEP)	ACF
Sheets per pack	5	2	2
Thickness	0.15 mm	0.15 mm	0.3 mm
Light transmission	≥ 95%	≥ 95%	High (frosted finish)
Model release	Good	Excellent	Excellent
Service life	Standard (typically 20–30 prints)	Long (typically 2–3× FEP)	Long
Finish	Clear	Clear	Frosted / textured

Key Features

Cut to fit: exact vat-frame size for the listed printers, no trimming needed.
High durability: resists resin, UV and repeated peel cycles.
Excellent light transmission: even curing across the whole build plate.
Easy model release: low surface energy so prints lift cleanly off the film.
Packed flat: protective liners both sides, no creases or scratches.

Note for the Photon Mono M7 Max: this printer ships from the factory with a film that has pre-punched mounting holes. Our sheets are supplied cut to size without holes — trim and punch the mounting holes using your old film as a template before fitting.

Specifications