Release Film for Anycubic Photon M3 Max (395 × 265 mm) – FEP or PFA (nFEP)
FEP (5 pack)
$79.00
Release Film for Anycubic Photon M3 Max (395 × 265 mm) – FEP or PFA (nFEP)
$79.00
Pickup available at Gold Coast, Queensland. (Check Pickup Hours)
Usually ready in 2 hours
Order before 3pm for same-day dispatch via Australia Post. 2-5 business days to most of Australia. Shipping rates and policy
Free shipping on orders over $120 (excluding 3D printers)
Pre-cut release film for the Anycubic Photon M3 Max, cut to 395 × 265 mm so it drops straight into the vat frame with no measuring, no cutting and no wasted roll. Sheets are cut from fresh factory rolls, packed flat with protective liners, and shipped from our Gold Coast store.
Choose your film type from the Film type option above — FEP or PFA (nFEP). Not sure which to pick? See the comparison below and in the product images.
Changing your film is a ten-minute job — follow our Installation Guide.
Which film should I choose?
- FEP (5 pack) — the proven everyday film. Standard fluoropolymer release film. Clear, affordable and forgiving. Five sheets per pack so you always have spares on the shelf.
- PFA nFEP (2 pack) — lower peel force, longer life. nFEP is a PFA-based film with a lower surface tension than FEP, so models release with less peel force. Gentler on fine supports, quieter, and it lasts noticeably longer between changes. Two sheets per pack.
| FEP | PFA (nFEP) | |
|---|---|---|
| Sheets per pack | 5 | 2 |
| Thickness | 0.15 mm | 0.15 mm |
| Light transmission | ≥ 95% | ≥ 95% |
| Model release | Good | Excellent |
| Service life | Standard (typically 20–30 prints) | Long (typically 2–3× FEP) |
| Finish | Clear | Clear |
Key Features
- Cut to fit: exact vat-frame size for the listed printers, no trimming needed.
- High durability: resists resin, UV and repeated peel cycles.
- Excellent light transmission: even curing across the whole build plate.
- Easy model release: low surface energy so prints lift cleanly off the film.
- Packed flat: protective liners both sides, no creases or scratches.
Specifications
- Dimensions: 395 × 265 mm
- Compatibility: Anycubic Photon M3 Max
- Film types: FEP (5 pack) · PFA nFEP (2 pack)
- Thickness: FEP and PFA (nFEP) 0.15 mm
- Light transmittance: ≥ 95% (FEP / PFA (nFEP))
- Temperature resistance: FEP 205 °C continuous / 260 °C peak
- Brand: NovaFEP release film, stocked and cut by 3docity
Compatibility is based on the vat-frame film size. If your printer isn't listed but uses the same size, it will fit — ask us if unsure.
fep-film-anycubic-mono-m3-max-395-265
